New K1 Prodigy Loading Instructions

Revised Loading Instructions For The KBox Prodigy

1. Using A USB Stick with your Kbox, And Downlaoding The newest File
Located In the files area , Ensure you pick the right file. as there are
2 Kbox fta receivers - K1 PROdigy and K1 Plus
If you choose the wrong file, it will say Invalid Firmware

2. Connect the KBox to the coax, and plug the KHub into rs232 port on rear of receiver, and power On. The KHub is Powered by the receiver.

3. Load the UNZIPPED latest bin, (or later as they are released), onto your USB.

4. Insert the USB into the USB port on front of receiver.

5. When the explorer screen appears use the remote arrow buttons to highlight the bin, Press OK

6. When the bin is done loading the KBox will reboot itself.

7. Go to Menu > Installation > Dish Settings, and Set up your Sat for scanning, and scan your Satellites

8. Go to Menu > Installation > Options> and Mode should be already set to Network.

9. Set ALL Auto Roll in the same screen to OFF.

10. The Hub has already been activated by the latest bin file.

11. Go to Menu > Configuration > Network Settings and wait for screen to say Connection OK

12. Using the switch on the rear of the KBOX, reboot the KBox.

Tune to an ACTIVE NAG 3 channel, (CNN 200), is a safe one. Then wait a couple of minutes and tv should begin to play.


End C/P