Network Adapter Connection set up

NETWORK ADAPTER CONNECTION



1. Connect Adapter power cable to power line

2. Wait until adapter light change to green from orange (located on the top of adapter)

3. Connect network cable comes from modem or router to Network adapter

4. Power off NEOSAT receiver

5. Connect Adapter cable to RS‐232 port in the NEOSAT (back side)

Connect provided Adapter power cable
and connect the other side to power line
Adapter Light
Connect Network cable which comes
from the Router or modem to here.

6. Power on the Neosat receiver.

7. Screen will show installation wizard.

8. Follow the step and set up the installation.

9. During the installation wizard, if you didn’t scan channels, Press menu/ installation/antenna setup and
scan channels.

10. After scan channel, press F4 button on the remote control.

11. Input Serial number which attached backside of adapter.

12. After input serial number, press green button (disconnect) and press red button (connect). It takes 2/3
seconds for processing.

13. Press exit button on the remote control.

14. Press F4 button again and you can see the serial number.
15. Ready to use.

16. In order to get new file, press F3 button and press red button and check if new file is available.



If your adapter dosen't have the 23 character serial number
that means that the serial key is encrypted in the adapter.
__________________

__________________




Testing: Sonysat DCR5500, pansat 9000hd, sv4k, sv360premier, pansat 2700a, coolsat 6000 and satopia ST1100-UT