Help with wall program

Everytime I try to open the wall program it gives me a message that pops up and says Could not acquire I/O. Windows NT/2K users must have administrative rights. Can't get past this. Can you tell me what I am doing wrong. Thanks

Hello I just saw your post and I personally have not seen or heard of that problem.
What operating system are you actually using? can't be NT or 2K I hope LOL.
as far as the I/O issue if you bought your jtag cable on EBAY it could be that you will need to file the index key off the jtag header plug so you can plug it in the other way.
I don't know why but I have been hearing this over and over from many sources.
you can also confirm the polarity by using an ohm meter. My last conversion guide goes into trouble shooting jtag problems in detail and specifically addresses the polarity issue and detail with pictures on how to check with an ohm meter.
I spent a lot of time on that I think it would be a shame if folks didn't take advantage of it.
Well good luck and if you can post your latest results and also your operating system we should be able to get you going right away. If you post and I don't answer right away PM me so it will email me and I can read your info to get you going.
aairon/fugley.

Install Microsoft Net Framework and your problem will be solved. You can Google "dotnetfx.exe download" to get a link to the download.

Regards,

Harp